Galactic Hunter

Active Hunter
Can anbody tell me what the correct size is for the screen that goes behind the keyholes on 's helmet? Is the size just like regular screen door mesh?:confused


I used regular screen door/window mesh. You can buy it at Home Depot. I hot glued a rectanglular piece inside the bucket large enough to cover all the keyholes and then I cut another rectangular piece the same size only this time with the mesh going in a diagnoal pattern to "cross" the first piece and minimize the view into the helmet of the back of my head with the bucket on. I glued that one on top and presto. Hope this makes sense. I can take a close up picture if you need me to.
This is a pic of the real helmet. Hope it helps. The first pic is from the Paris helmet and the 2nd is from the C2 armor.


Last edited by a moderator:
This thread is more than 17 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.