In need of a longer Stalk

Thread starter NoZoupForYou
Start date Jul 14, 2021

NoZoupForYou

Hunter

Jul 14, 2021

Hey all... I printed off a Fett repaint bucket and am nearing completion. The file is printed at 107%. As such, normal sized stalk seem too short. Anyone know where I can source a longer stalk, around 7.5" or so? Thanks.

This thread is more than 1 year old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.