helmet is to loose



I have a rubies boba fett helmet and I is way to loose on my head.Anyone have an idea on how i can make it fit tight on my head?
Put foam padding in there...or wear a cap or beanie on your head...Since the Rubies is small there's not enough room for a construction helmet liner, but some foam should do the trick.
boba freekk filled with ideas you are! how do I mount foam or a hard hat liner in there?
You might want to try just plain old craft foam from your local fabric store and hot glue it into place. Personally, my chin sticks out the bottom of a Rubies so I never have to worry about putting padding into it.
i saw that and it looks like it will fit me perfectly.any tips on a easier way to do that?
This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.