gauntlet weathering

M

mike

Guest
I've seen many posts about weathering the body armor but none on weathering the gauntlets. I'm doing PVC gauntlets so dents probably wont work. Any help would greatly be appreciated
 
There aren't any "dents" per se on the gauntlets. There are the square indentations on the bottom of the shells (3 on the left and 4 on the right ) which could be replicated by cutting out the square completely, then gluing a thinner flat piece of plastic on the insides.

As for actual "weathering," that is done with various paint techniques which could be applied to any pair of gauntlets.
 
This thread is more than 21 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top