ESB to ROTJ conversion...

ok, I know this is a relativly old thread, but someone asked how my jet pack was attached.

since he has use for this info, I gues several others might aswell :)

it's nothing new, but here it is...

the picture shows 2 iron hooks on my jet pack (wich is attached to my mannequin with iron wire as it didn't fit my harness system.)
but when I wear it the harness system goes over my jumpsuit and under my vest and backplate, then the hooks "grab" into the "D" rings, and for extra attachment I got a belt around my waste that was attached to the pack.

simpel I gues... but it holds :)

jetpack clamp.JPG


harness.JPG
 
This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top