Dose this look right???

[orionx42]

Ok so here is the closest I've gotten right now with the armor. I'm currently working on my vest and my helmet and some metal armor but when I held this up it looked a little off. I figured I'll make the collar bigger but other then that I figured I would ask around and get some opinions on it. I used the medium armor sizing due to hight but I wasn't sure if maybe I should go up one to the lower end of the large or what. Any suggestions?

 

[Jango72]

It doesn't look all that much off, perhaps just a tad on the big side. It's really difficult to tell from the picture. But I would certainly not go any bigger.

Are you making this Boba armor, Jango or a custom?

 

[orionx42]

I not really sure... most likly Boba, but I'm also planing a mando-variant as well. I know it will be a tad smaller once I sand it. I'm thinking the collar is to small at least on the parts that go over the shoulder.

 

[Jango72]

*whoops... double post* :facepalm

 

[Jango72]

Please keep in mind that the shoulder armor should be the same width as the chest plates.

Your best bet, at least this is what I did, is to use the ab plate as a gauge, then base the rest of the armor plates from it. Keep in mind that there should be a consistent 1 to 2 inch gap between the plates.

Another point to keep in mind when sizing your ab plate, is that it should sit above your waist/girth belt ( not covered by the girth belt at all ), this will aid you in finding the correct size for your body size. :cheers

 

[orionx42]

Awesome! I'll make sure to keep that in mind. Thanks.