Custom RF Stalk?


Not really sure where to put this but was wanting to know if anyone on the board can make a custom aluminum stalk using a 3D model. I'm working on a helmet and need a RF stalk that is slimmer and slightly different than Boba's stalk. Would love some names of vendors I could talk to.
This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.