Casio MQ-1 resin cast

batkit

batkit

New Hunter
Hi everyone
I'm new on the forum from the UK (wales)and working on an ESB helmet hopefully have some in progress shots soon. Is there anyone doing resin casts of the Casio MQ-1 to fit behing the rear slots ? I have seen some 3d printed ones but they are too grainy.
 
This thread is more than 5 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

Similar threads

SalaciouCPhD
Question about in-helmet molded Casio MQ-1 Circuit board
Replies
2
Views
243
viewoptic
viewoptic
trmee001
Bended resin
Replies
5
Views
908
trmee001
trmee001
Fettguy85
Buying G2 ESB raw cast helmet
Replies
0
Views
779
Fettguy85
Fettguy85
Indy Magnoli
1313 Helmet Build
Replies
14
Views
1,749
Indy Magnoli
Indy Magnoli
Strikerkc
Green "resin(?)" Don Post Fett helmet materials/safety?
Replies
6
Views
968
jhfagan
jhfagan

Similar threads

SalaciouCPhD
Question about in-helmet molded Casio MQ-1 Circuit board
Replies
2
Views
243
viewoptic
viewoptic
trmee001
Bended resin
Replies
5
Views
908
trmee001
trmee001
Fettguy85
Buying G2 ESB raw cast helmet
Replies
0
Views
779
Fettguy85
Fettguy85
Indy Magnoli
1313 Helmet Build
Replies
14
Views
1,749
Indy Magnoli
Indy Magnoli
Strikerkc
Green "resin(?)" Don Post Fett helmet materials/safety?
Replies
6
Views
968
jhfagan
jhfagan
Back
Top