Boba Fett helmet - Scratch build. Need help

bobanotfat

New Hunter
Hey guys, I'm new here and still figuring my way around this awesome site.
Anyway, I'm pretty new to all these prop making and pepakura stuff and I've just started trying my hand at a boba fett helmet.
I am aware that there quite a few pep files out there and pretty good ones too. But i felt adventurous and I decided to make it from scratch. I plan to go all the way with fiberglass resin and bondo. I already familiarized myself with it so no worries on that.

Anyway I free handed this boba fett template on a piece of mounting board with reference from pictures of boba on the internet. All I used was a ruler, estimates and my head (literally cause i had to measure to fit). haha Oh bad joke. I shouldn't have tried. Anyway, this is what I have so far.

20150512_234519.jpg20150513_001531.jpg20150513_180035.jpg20150513_172234.jpg

I noticed that the visor hole extended a bit too far back and I'm planning to bring it back forward in the later stages when I begin resin and bondo. The chin area was also a bit too long but I already took care of that. This is where I so desperately need help and advice. I can't figure out how to properly construct the dome on this guy. I tried triangular paneling by freehand and eyeballing on a previous helmet build attempt(it was rubbish so i threw it away) but as expected it became roundish. I did find files for the dome online but i don't think it's gonna fit this dimension. I tried googling but I couldn't get much. Any idea how I could effectively build that nice round-flattish dome?

I would really love to see this project through and have a decent helmet at the end. I'm making early preparations for this year's Epi 7 premier. I'm not expecting screen accurate product at the end but a nice looking helmet would be extremely gratifying. I could wear it to the premiere or use it as a popcorn bucket holder and go dress as a clone trooper while I eat from it. Sick. I know
sad.png


Help? Please?
 
Hey thanks for helping me out. I got so stuck I abandoned it for a while to work on a rocketeer helmet. I'll try out your templates soon. It's looking good :)

- - - Updated - - -

- - - Updated - - -

Yes, sir! haha :)
 
There are lots of templates on here including tutorials and great paint ups. Do what I do research the **** out of what you want to do, that way it save you a lot of grief in the long run.
I was a great start though, my First bucket back in 99 started that way (though I used a bucket) and boy did I get a headache building that.....:lol:
 
This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top