Blaster pieces warped How to straighten?

You could try the hot/cold water method.
Run some water so that it gets really hot (don't use boiling water) and hold the piece under the water.
When you're able to bend it--gently--hold it in the position you want and then run it under cold water.
 


Write your reply...
This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top