Accurate Gauntlet Darts - Interest?
- Thread starter Mojo Fett
- Start date
Skupilkinson
Active Hunter
Looking forward to seeing it Gav!!!!!!
Mojo Fett
Well-Known Hunter
Skupilkinson
Active Hunter
The time won't pass any quicker bro. 
Mojo Fett
Well-Known Hunter
What hour do you finish working?
It's 15:45 here and don't finish till 17:00 then an hour to get home...
Mojo Fett
Well-Known Hunter
Ok so at 7:00 PM aprox. (Spain) I can read the news 1 hour before you...
j/kSeeker, what are you going to do with the 2nd set, hum?
Skupilkinson
Active Hunter
Kaane, I don't think you're excited enough mate. How about you show some more entheusiasm?!!
Seriously though, lookin forward to seeing them bro.
Seriously though, lookin forward to seeing them bro.
Skupilkinson
Active Hunter
Sorry, double post. :0
Mojo Fett
Well-Known Hunter
Ok..
Picked it up this evening and I'm really happy altho I have 2 small concerns to address before I do a run.
1. As a machinist he has put a small 0.25mm chamfer at either end of the main body (which wasn't on my CAD drawing)
2. The O/D of the thread is 0.2mm smaller than the original.
I have measured the length / diameter etc... and they are spot on other than the above issues.
I'm gonna get him to correct these and check again
A couple of pics...
Picked it up this evening and I'm really happy altho I have 2 small concerns to address before I do a run.
1. As a machinist he has put a small 0.25mm chamfer at either end of the main body (which wasn't on my CAD drawing)
2. The O/D of the thread is 0.2mm smaller than the original.
I have measured the length / diameter etc... and they are spot on other than the above issues.
I'm gonna get him to correct these and check again
A couple of pics...
Mojo Fett
Well-Known Hunter
I can try... :facepalm
The only other thing I noticed and forgot to say in previous post was that the original has 'flat' peaks on the thread form and the prototype is pointed... therefore he's gone in slightly too far (0.2mm) and compensated in the O/D hence being 0.2mm smaller...
The only other thing I noticed and forgot to say in previous post was that the original has 'flat' peaks on the thread form and the prototype is pointed... therefore he's gone in slightly too far (0.2mm) and compensated in the O/D hence being 0.2mm smaller...
Skupilkinson
Active Hunter
Woah!!! Nice work my friend!!! Very nice!
Mojo Fett
Well-Known Hunter
I can't find the correct word, I'm going to create a new word for the final version so keep up the quality
Cheers for the vote!
Don't worry I'm gonna get these tweeked and have a final design very soon...
Similar threads
