3D ROTJ helmet

[BonzaiFett]

A long time ago I discovered the templates of RafalFett and tried to build the helmet with cardboard and then with polystyrene.
I don't know what to say, but both were not very successful.
After I was allowed to call a 3D printer my own last summer, there were new possibilities.
I was looking for 3D models of the helmet, but they didn't have the quality I had hoped for.
Until I (again) came across the 3D project of RafalFett.

RafalFett: Thanks for your amazing work!

Since the files had a too low resolution, I started to completely redesign the helmet.
And after 9 months I'm hopefully finally done and ready for printing.

Long story short, what do you think?

 

[MinuteFett]

Looks really good! But the back panels look a bit off, as if on is a bit short than the other.

 

[RafalFett]

As I already said in PM, this came out great! And thanks for the kind words!

 

[BonzaiFett]

Looks really good! But the back panels look a bit off, as if on is a bit short than the other.

That should be all right. The helmet is not symmetrical and on the reference pictures it also looks like that.

 

[whistler9981]

are you selling the 3d printing files or are you just using them for personal use...was just curious

 

[BonzaiFett]

are you selling the 3d printing files or are you just using them for personal use...was just curious

The files are for personal use only. I shouldn't sell them either, because the model is based on the work of RafalFett.

 

[BonzaiFett]

It took a while, but here it is: Printed, filled, physical damage added and primed.
Next step: Paint job.

 

[SouthHunter]

Amazing!!! I´m planning on making one for me, is it ok if I ask for the files?