helping a nonclone

Creon

Jr Hunter
hey all!

im not sure if im allowed to put this here since its not for a clonearmor but a mando beskar. however since the mando im making is heavy and more related to clone armor than traditional mandalorian, i figured i should someone with experience in that area.

the problem i have is with the codpieve/butplate. im making both as a single piece, joined by a ring or belt, from scratch. what im really wondering is how to make all the curves in the cod piece and but plate. any tips hints or ideas would help

cheers!
 
I assume you will be using plastic to create the cod and rear armor? It's depends on the meduim which will determine the method. Be glad to help Creon!
 
Last edited by a moderator:
actually, im combining sintra plastic and 4mm cardboard. i have done so for several other parts of my armor and it works.

i managed the codpiece yesterday btw, so all thats left is the rear plate.
 
This thread is more than 14 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top