About to invest in a Fettronics board and I've been corresponding with Jon with a few questions regarding dimensions, but I'd like to get some input in regards to correct light display/sequence.
Since I have Bobamaker chest armor it was cut to fit TK-409's chest display, and since it's already painted up I really can't dremel/file it. Jon said the 4mm version of his chest display will fit for the TK-409 cutout. Anyone have any problems with the standard 5mm version fitting in their Bobamaker armor?
Next comes which version...
I've seen some debate on whether or not its a 20 bar top, or 5 Bar top. From the research I did in "seven"'s thread, I didnt see any conclusion but I'm assuming from the first pic it's the 20 bar?
Then there's the sequence...its offered as Basic 2 step, Fast 2 Step, Don Post Sequence, etc. Has anyone came to the conclusion which sequence was the most correct?
If anyone a lot more knowledgeable about chest displays can help me out on this, that would be awesome. Gotta make sure I make the right purchase so I don't end up kicking myself later on.
Since I have Bobamaker chest armor it was cut to fit TK-409's chest display, and since it's already painted up I really can't dremel/file it. Jon said the 4mm version of his chest display will fit for the TK-409 cutout. Anyone have any problems with the standard 5mm version fitting in their Bobamaker armor?
Next comes which version...
I've seen some debate on whether or not its a 20 bar top, or 5 Bar top. From the research I did in "seven"'s thread, I didnt see any conclusion but I'm assuming from the first pic it's the 20 bar?
Then there's the sequence...its offered as Basic 2 step, Fast 2 Step, Don Post Sequence, etc. Has anyone came to the conclusion which sequence was the most correct?
If anyone a lot more knowledgeable about chest displays can help me out on this, that would be awesome. Gotta make sure I make the right purchase so I don't end up kicking myself later on.