Progress pics of my MLC Fett Armor

Thanks for the feed back guys, I'll post a little write up tomorrow when I get a moment, I'll keep you guys updated as I go along :)

-Aaron
TK080
 
Nice work, I have the same set of armor and it's great! A tip on those shoulders - Fill the sink with cold water. Heat oven to 350'. Pop one in the oven for 1.5 minutes. Pull it out with hot gloves and spread it out (a little flatter) so it's not such a pipe look. Then quickly immerse it in water to hold the new shape.

Nicely designed photo gallery too!
 
Great job! I'm actually waiting on a set of MLC Fett armor, so your pics will be quite helpful in my painting process.
 
This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top