Reply to thread

Interesting „issue“ that happen to me. As I usually brush my ABS prints with acetone to enhance layer adhesion it happend that I got some aluminum powder to freshly brush area. After letting it dry i sanded it and saw that it looks like real aluminum. So I decided to do a little test and brush everything properly with acetone and aluminum powder. When it was dry I sanded with 600 grid and buffed it a bit. On the picture you can see the result. I am really impressed as its very close to real aluminum and cold cast. [ATTACH=full]190542[/ATTACH][ATTACH=full]190543[/ATTACH]


This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top