Reply to thread

The front of the helmet has not escaped shrinkage. All of it has shrunk to some degree and there does not seem to be a common factor of shrinkage. Some parts may have shrunk by around 5% but some parts may have shrunk less, some parts more. I think what you're observing here is that the most noticeable shrinkage has occurred in the dome and that this gives the face a disproportionately large appearance.


Measurements provided for the inside of the straight edge of the mandibles of the PP2 indicate that the left mandible of the GMH had lost 8mm along this edge and the right mandible had lost 7mm.


This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top