Reply to thread

If you glass the inside of the gauntlets make sure that the heat doesn't warp the plastic.  You can use a cold cure resin that will not heatup while it cures.  That's what I did for mine and it worked great!


BTW I just bolted my two outer halfs together and used velcro on the inside.


Loranar


This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top