Reply to thread

Velcro is the way to go.

as far as the rivets;

on the left gauntlet,rivet  the flamethrower  on as well(leave the bottom piece off when you rivet,then glue it together.)

on the right rivet the outside edge of the gaunt,I only used 2 rivets -one on each end.


This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top