Reply to thread

Message

I have the MARROW_SUN and it fits well and is very reasonably priced.
Here is a pic of me with it on and mind you, the ears are not attached and I thought the flair was nice.

http://pg.photos.yahoo.com/ph/e2k13/detail?.dir=3c4c&.dnm=38b5.jpg&.src=ph

I am 6'1".
I love the M_S. That doesn't go to say that the others are not good but I just wanted to chime in that the M_S was a well crafted and well shaped helmet if you are really looking.

As far as the cutting and sanding, it is all up to the buyer. M_S does trim and prime them if asked but it will cost to have him do that.
I went the cheaper route and bought the raw cast so I could do the work myself but I have seen the ones that he has cleaned up and primed and highly recommend them!

<blockquote data-quote="E2K13" data-source="post: 37504" data-attributes="member: 442">I have the MARROW_SUN and it fits well and is very reasonably priced.Here is a pic of me with it on and mind you, the ears are not attached and I thought the flair was nice.<a href="http://pg.photos.yahoo.com/ph/e2k13/detail?.dir=3c4c&amp;.dnm=38b5.jpg&amp;.src=ph" target="_blank">http://pg.photos.yahoo.com/ph/e2k13/detail?.dir=3c4c&amp;.dnm=38b5.jpg&amp;.src=ph</a>I am 6&#039;1&quot;.I love the M_S. That doesn&#039;t go to say that the others are not good but I just wanted to chime in that the M_S was a well crafted and well shaped helmet if you are really looking.As far as the cutting and sanding, it is all up to the buyer. M_S does trim and prime them if asked but it will cost to have him do that.I went the cheaper route and bought the raw cast so I could do the work myself but I have seen the ones that he has cleaned up and primed and highly recommend them!</blockquote>

[QUOTE="E2K13, post: 37504, member: 442"] I have the MARROW_SUN and it fits well and is very reasonably priced. Here is a pic of me with it on and mind you, the ears are not attached and I thought the flair was nice. [url="http://pg.photos.yahoo.com/ph/e2k13/detail?.dir=3c4c&.dnm=38b5.jpg&.src=ph"]http://pg.photos.yahoo.com/ph/e2k13/detail?.dir=3c4c&.dnm=38b5.jpg&.src=ph[/url] I am 6'1". I love the M_S. That doesn't go to say that the others are not good but I just wanted to chime in that the M_S was a well crafted and well shaped helmet if you are really looking. As far as the cutting and sanding, it is all up to the buyer. M_S does trim and prime them if asked but it will cost to have him do that. I went the cheaper route and bought the raw cast so I could do the work myself but I have seen the ones that he has cleaned up and primed and highly recommend them! [/QUOTE]

This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification