Reply to thread

Message

I finally got around to 3D printing a blaster to stuff into my holster. This is the final revision from Straeker from Thingiverse. I think it is a little undersized but it fits the holster I made beforehand perfectly, so it will do. I tweaked a couple of small details and replaced the grips with some wood ones I whipped up this afternoon.
[ATTACH=full]202837[/ATTACH]

[ATTACH=full]202836[/ATTACH]

I wet formed the holster a bit to get the shape to conform to the blaster.

Grogu approves!

[ATTACH=full]202838[/ATTACH]

[QUOTE="bigkidbiggertoys, post: 506187, member: 45"] I finally got around to 3D printing a blaster to stuff into my holster. This is the final revision from Straeker from Thingiverse. I think it is a little undersized but it fits the holster I made beforehand perfectly, so it will do. I tweaked a couple of small details and replaced the grips with some wood ones I whipped up this afternoon. [ATTACH type="full" alt="IMG_1641.jpg"]202837[/ATTACH] [ATTACH type="full" alt="IMG_1640.jpg"]202836[/ATTACH] I wet formed the holster a bit to get the shape to conform to the blaster. Grogu approves! [ATTACH type="full" alt="IMG_1642.jpg"]202838[/ATTACH] [/QUOTE]

This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification