Reply to thread

So I am working on a few upgrades and will post here as I get farther along. I decided to  make another helmet so purchased the Great Ape file and printed it. Pretty much same process as the first one I built but this time around I am using an SLA printer for the detail parts


This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top