Reply to thread

A few small details that I added tonight. I didn't have all of my ammo machined for the gun belt so I finished this off today. Like the leg armor, I opted to use double faced tape to secure these so I don't have them moving around or accidentally lose one. I'm calling the gunbelt done until I print my blaster and then I can do the final wet form on the holster.[ATTACH=full]201004[/ATTACH][ATTACH=full]201002[/ATTACH]


This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top