Reply to thread

I worked on the gauntlet closures recently. I used the removable hinge pin method that is good for Jango. Because the hinges are hidden on Mando I had to use a different method to make a movable hinge. I decided to glue in some 2" elastic strap using Cyanoacrylate adehesive and added a couple of strip of velcro to finish the ends. This isn't necessary but I always strive for a finished look and if I need to add velcro to the suit to keep the gauntlets from rolling it is already there.  The hinge was glued in with epoxy and I scuffed and cleaned both surfaces.[ATTACH=full]199037[/ATTACH][ATTACH=full]199038[/ATTACH][ATTACH=full]199039[/ATTACH][ATTACH=full]199040[/ATTACH][ATTACH=full]199041[/ATTACH][ATTACH=full]199042[/ATTACH]


This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top