Reply to thread

Ok so I printed off a new form, this one not as wide but I still have it elongated front to back slightly. The benefit of this is 1) it fits my boots perfectly and 2) I am able to assemble this as an armor piece and won't have to worry about combing multiple pieces that I have to line up or could work loose.


It consists of the upper form with the knee attached and the lower skirt which is the only piece that gets velcro.[ATTACH=full]198742[/ATTACH][ATTACH=full]198741[/ATTACH][ATTACH=full]198740[/ATTACH][ATTACH=full]198743[/ATTACH]


This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top