Reply to thread

I have started work on the left leg. I printed the tombstone shape and added a quick layer of bondo as I didn't want print lines migrating through the leather. I wet formed and worked in the form with a bone folder to create the shape, then let dry overnight. I glued in the tombstone shape and then dyed the final color. The strap will be left long until final assembly.


This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top