Reply to thread

Message

A few updates but I'll first start with the lower leg armor. I printed off a new set that I modified to fit the boot I have so I don't have to modify the boot. I opted to use a paracord lace for the front under the center plate and I glued the plate in place so it won't move around. The paracord acts like a hinge when I put on the armor and snaps back into place. The only thing I would change is my lacing pattern. After I finished it occurred to me there was a better way but this works well so I will leave it alone.

[QUOTE="bigkidbiggertoys, post: 501878, member: 45"] A few updates but I'll first start with the lower leg armor. I printed off a new set that I modified to fit the boot I have so I don't have to modify the boot. I opted to use a paracord lace for the front under the center plate and I glued the plate in place so it won't move around. The paracord acts like a hinge when I put on the armor and snaps back into place. The only thing I would change is my lacing pattern. After I finished it occurred to me there was a better way but this works well so I will leave it alone. [/QUOTE]

This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification