Reply to thread

I have finished printing and painting the gauntlets. Just some details to add but I think I may try to spin these on my metal lathe. This is a new tool for me but I luckily I have a machinist friend willing to give me some pointers. Hell, he would probably spin everything off for me but I don't want to lean on him like that, I'd rather learn a new skillset.


This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top