Reply to thread

I also made up a paper template for the T-visor and cut it from a welding visor. It is just temporarily held in place with tape but I think I am going to print some sort of screw attachment method as soon as I get a chance. If anyone is interested I can scan the template and throw up a jpg.


This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top