Reply to thread

The dimensions confrim the clamp being on the Flash tube. The best way would be to compare the scope mount locations.  On my wireframe the forward face of the aft scope mount is 3" forward of the intersection of the barrel and the front of the chamber.

 

Alan


This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top