Reply to thread

I used a metal cross stitch frame rod.  I opneed it up and after it was hot glued in place, I covered it in superglue, THEN completely covered it in bondo.


That helmet will completely melt before the rod and glue come out.


This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top