Reply to thread

Hey anyone had this problem . I wanted to beef up my styrene armor . The crotch armor ( as it is under some stress ) tends to crack and split when bending etc . I thought I would use some of this truckbed spray on liner to beef it up . I sprayed it on kinda thick ( maybe that was the problem .. too thick ? ) and left it to dry . When I came back 5 min later the stuff was running in 1 big blob  :( . I quickly layed it flat and smoothed it out ( tradagy avoided ). Then a couple of hours later I checked it to see how it was doing a noticed the paint on the good side was bubbling aaaaaaaaaaarrrrrrrrrrggggggggg :angry . I also noticed that the styrene had gone very soft in some spots . I'm hoping with a few days when the truck liner has a chance to really harden so will the styrene . Heads up !!



Mike


This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top