Reply to thread

Message

well I started my first kit. Just some knee armor nothing to terribly complicated and I have one almost done its all glued together all I have to do is sand it and add the spikes since Its for my custom, but I wanted to get your guys opinion is there anything I can do to approve upon what I have done before I get started on the other knee?? so here are a couple of pics...Also one other quick question what the best way to add the back straps I am affriad they will just pop off if I use glue/apoxy.
[ATTACH=full]83031[/ATTACH]
[ATTACH=full]83032[/ATTACH]
[ATTACH=full]83033[/ATTACH]

[QUOTE="morpheus1977, post: 113381, member: 1390"] well I started my first kit. Just some knee armor nothing to terribly complicated and I have one almost done its all glued together all I have to do is sand it and add the spikes since Its for my custom, but I wanted to get your guys opinion is there anything I can do to approve upon what I have done before I get started on the other knee?? so here are a couple of pics...Also one other quick question what the best way to add the back straps I am affriad they will just pop off if I use glue/apoxy. [ATTACH=full]83031[/ATTACH] [ATTACH=full]83032[/ATTACH] [ATTACH=full]83033[/ATTACH] [/QUOTE]

This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification