Reply to thread

Well the best bet may be to do it like this.  See diagram number 1 and the other pics there on how to make the shoulder strap set up.  You could use that for under a ST ab plate and a fett ab plate i would think.  Then just find a way to get an extra microphone one for each helmet or have a clip so its removeable too.  The amp section is over to the right side of this site...


http://www.tk409.com/tk409.html


And hopefully TK409 doesnt mind this link....



dan


This thread is more than 21 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top