Reply to thread

Yup just throw that puppy in the oven at about 200 degress F and have a pair of cotton work gloves handy.  When you take it out in about 5 minutes it'll be flexible enough to make it the correct shape. I don't think you can blame him for using a think plastic.  You should have asked before you started bending it.  Lexan and Acrylic don't take well to bending without heat.


This thread is more than 22 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top