Reply to thread

Question for all of you out there in Fett Land! What is the best way to bend an acrylic visor so that it fits more flush against the inside of the helmet? I'm having trouble getting the visor on my current commission to fit properly and I don't want to damage the visor or the helmet. I read through the Visor installation thread but didn't see anything with regards to bending it. I read online that you are not supposed to heat acrylic in the oven because it emits gasses that can become explosive. Any help would be appreciated.


This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top