Reply to thread

Once I take it out of the oven at 300 degrees, can I then lay it right on the helmet fiberglass, to get the shape? I was worried that the hot plastic would be too hot for the fiberglass helmet, and maybe burn or warp it.


This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top