Reply to thread

Yep, if it is acrylic you can put it in the oven at about 300 degrees for 10 minutes.  I have also had good luck using a heat gun.  It let me apply the heat exactly where I needed it without having to reshape the whole visor.  This might be the method you want to try first.


This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top