Reply to thread

I purchased a visor on ebay but the curvature of the eye section is way too much plus it's got virtually no flexability. What would be the best way to sort this out?

I have tried puting it in hot (not boiling) water but it was having none of it.

Any suggestions would be much appreciated.


This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top