Visor Installation


i am getting a full day off from work so i am going do try and finish the painting on my custom mando bucket and then get the visor installed. My question is about the best way to do this. I have read any thing from using metal brackets to hot glue gun to hot melt caulk. Being that the don post 97 is not fiberglass i need to know the best way to get the visor to stay in place. Looking forward to any help you can give as i have decided that TDH is now my bible for doing this costume..........:thumbsup:
This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.