Reply to thread

Message

That Ebay one would most likely be too short. The MLC is a LOT bigger than a DP.

The welding visor I bought is wide enough. In the very corners it has the stamp from the visor but you can't see it in the helmet.

Failing all of this, you could try www.gepolymershapes.com and see if they can sell you a square of tinted plexi.

[QUOTE="Jodo Kast 2749, post: 35808, member: 342"] That Ebay one would most likely be too short. The MLC is a LOT bigger than a DP. The welding visor I bought is wide enough. In the very corners it has the stamp from the visor but you can't see it in the helmet. Failing all of this, you could try [url="http://www.gepolymershapes.com"]www.gepolymershapes.com[/url] and see if they can sell you a square of tinted plexi. [/QUOTE]

This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification