Reply to thread

i'm nearly done painting a Rubies (i know :lol: ) and am nearing the stage where i'll need to cut out and attach a better visor (in this case Boba Makers).  i was wondering what the best method for cutting out the existing "visor" and attaching the new one was.   i was going to dremel but i'm not sure... any suggestions from the wise members of TDH would be GREATLY appreciated.:D

Thanks


This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top