Reply to thread

When I used this bucket for my conversion I noticed that over time, the dent "repaired" itself. I wound up having to put the dent in deeper than it should have been and I also held the dent in while I used an ice cube on the other side. It "repaired" to about half the depth I made and stayed that way since. I hope you dont run into this problem...


This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top