Reply to thread

Vinyl? I mean really, there is too much leather waste just for the vest. I have seen some vinyl, it looks exactly like leather and you can't tell the difference AT ALL. I can't imagine getting like 6 lamskin hides just to make a vest. We'll see. I mean my seamstress did it out of vinyl...


Or, better yet, why not, all the outside pieces = leather, and facings = vinyl?


just a thought.Actually, I heard that it's not good to mix fabrics due to consistency issues, some act different than others. Ie, some gather and bunch more than others when sewing. So, mebbe a bad thought? Any people who sew out there that can answer this question? vinyl + leather?


Edit** 8/1 I went ahead with ebinger brothers I got 4 white lambskin hides approx 35.5 sq. ft. at $122 shipped. If you want to do the same, call and ask for Peter. Tell him you are a friend of mine, and that you need enuff hides for the same vest dimentions that I gave him. He will then mark the backs of the hides with numbers corresponding to the vest leather dimentions above. He managed to get all dimentions barely on those four hides, but you should ask for 5 just to have enuff to test paint/make cumberbun etc. (i ordered another hide a day later) I am going to have the vest made by my seamstress, hopefully, it all works out, there was some problems with her pattern right now due to sewing on such thick vinyl. She couldn't get some of the seams/panels to line up correctly. I will see her tomorrow. The lambskin is actually a lot thinner and pliable than vinyl.  So, final patterning might wind up being off of my leather vest.


This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top