Reply to thread

For sure.


I pulled up your cap models in Cura to get a rough idea on the diameters.  Then, some Googling showed people would build jetpacks using cardboard shipping tubes.  Seems like the most common sizes are 2", 3", and 4", so I just ran with it.


As far as I know, there's no reason to keep any 6" diameter tubes on hand for a jetpack build, and I can't think of any Boba-related use for them.


This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top