Reply to thread

I basically used the same set-up as mobius, seems to work very well.  Velcro might work, but wouldn't there still be somewhat of a gap between the inside of the bucket & the visor??  Also, the nut/bolt method seems to offer at least some support for the mandable area, keeping the verticle portion of the visor cutout strait. (I don't know how your bucket is, but mine seems a bit flimsy without the visor in it, and the verticle portion seems to lean towards the center near the bottom of the bucket)  would you still have the necessary support keep the verticle portion strait using velcro???  Just a few thoughts;)If you do go with the velcro method, please let us know how it works out.

Damian


This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top