Reply to thread

Top o' the mornin' to ya!  I ran a search but couldn't find a previous post on this.  I'm just finishing up my new MLC bucket (pics coming soon if I don't kill myself before this $#$##$%!#$&^ paint job is complete.  I bought some hot glue sticks for attaching the visor but wanted an even easier method of removing the visor if it gets scratched up. 


What I wanted to do was stick a number of small velcro strips along the edge of the visor (1" x 1/4") and stick corresponding strips along the edge (inset 1/8" from edge) of the T opening in my helmet.  The velcro should hold it well but also allow easy replacement of the visor.  Has anyone used this method before?


This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top