Reply to thread

My helmets are all going epoxy. Skyfire GMH helmets are also epoxy. Better quality. Less shrinkage.


And doing an outer polyurethane and backing it with polyester is just wrong since they’re incompatible. **** falls and those materials will separate.


This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top