Reply to thread

Oh. Ok. To get this "more" right... Can someone tell me more about Gino? Like, what his position at efx was or is? What his skillset is? Is he actually on here? Please forgive if some of those questions are either well known or easily researchable. I have read an extensive amount of threads on here but do not remember reading a lot about him.


Edit: Could we say, he was responsible for the molding? or the molding and the casting? Or the entire project?


This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top