Reply to thread

Thanks for the words cylrul :)


Well, I've already modified the AB plate. I've cut a bit the top part, and I've extended the sides with two small sintra pieces.


[ATTACH=full]84026[/ATTACH]


[ATTACH=full]84027[/ATTACH]


I think now It looks more accurate and more in proportion (I found it a bit small), But I also think I should cut the top a biiiit more, changing also the angle a bit, what do you think guys?


[ATTACH=full]84028[/ATTACH]


[ATTACH=full]84029[/ATTACH]


This thread is more than 17 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top